|
|
|
 You can build bridges, or you can burn them. The choice is yours. - dlavery [more] |
 |
|
|||||||
|
||||||||
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| You can build bridges, or you can burn them. The choice is yours. - dlavery [more] |
|
|
|||||||
|
||||||||
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
drill motor drive shaft attachment
Posted by Dennis Sipe at 1/8/2001 11:25 AM EST
Engineer on team 'Bot'ler Associates' from Linganore High School, Frederick, MD sponsored by NASA/GFSC and Smiths Industries. in the kickoff, Woodie held up several new parts that are intended to make it easier to connect to the drill motor. hub stuff and something else. I believe he said it wasn't in the kit and could be purchased somewhere. What are the exact details? thanks dennis |
|
#2
23-06-2002, 22:32
|
|||
|
|||
|
Small Parts
Posted by Ken Leung at 1/8/2001 11:55 AM EST
Student on team #192, Gunn Robotics Team, from Henry M. Gunn Senior High School. In Reply to: drill motor drive shaft attachment Posted by Dennis Sipe on 1/8/2001 11:25 AM EST: Those parts can be purchased through Small Part Inc. There should be a section in your manual around "The Robot Appendix" describing those hubs and connection to the drill motors... etc. And you should look up the contact information and see how to buy the parts from Small Part Inc. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
| Securing hex shaft to drill output | D. Gregory | Technical Discussion | 6 | 24-01-2003 14:05 |
| Need Help on Shaft Mounting... | archiver | 2001 | 3 | 23-06-2002 23:29 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drill Motor and FP Motor Shaft Diameters | Andy Baker | Motors | 4 | 11-06-2001 20:12 |
Linear Mode
