pic: Top Down Gearbox View

08-11-2008, 12:33 AM

Cory

Registered User

AKA: Cory McBride

FRC #0254 (The Cheesy Poofs)

Team Role: Engineer

Join Date: May 2002

Rookie Year: 2001

Location: Redwood City, CA

Posts: 6,787

Re: pic: Top Down Gearbox View

Quote:

Originally Posted by RMS11

So I should be more worried about gears slipping or shearing because of the thickness?

You'd probably run into problems with teeth shearing off.

3/8" face width 20 DP is generally the defacto gear type for FRC drivetrains.

Depending on the type of load you'll be seeing, you can increase DP or reduce face width in earlier stages. In output stages you probably don't want to go less than 3/8" face width and 20 DP.

Again, there is math that will verify these rough guesses, but that's a bit more complicated.

__________________
2001-2004: Team 100
2006-Present: Team 254

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Virginia's DREAM top view	falconmaster	Extra Discussion	7	01-25-2008 06:49 PM
pic: Top view Cheesed robot	falconmaster	Extra Discussion	4	01-18-2008 12:03 PM
pic: A View From the Top	CMB	Extra Discussion	2	01-10-2007 10:21 PM
pic: Top View of Shaft Drive	MAteo9944	Extra Discussion	2	12-30-2006 08:59 PM
pic: Team #910 Top View	CD47-Bot	Extra Discussion	7	03-06-2003 12:41 PM

All times are GMT -5. The time now is 06:04 AM.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.