|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: How to clean a Victor?
Yeah man, stay away from the compressed air... not only are you driving stuff deeper. If your using a standard shop air compressor set up, your tossing oil & water all over everything.
![]() Shop vac the better way to go, I always use a small soft paint brush to help loosen anything chips that might be bothersome about being sucked up. Don't forget your PPE's when doing it and be sure the robot is powered down. -p ![]() |
|
#2
|
||||
|
||||
|
Re: How to clean a Victor?
yeah and if you use the small can of air dont turn it upside down you will freeze it lol
![]() |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Clean Field! | Joe Matt | Extra Discussion | 6 | 19-03-2006 00:00 |
| Victor 884's not behaving the same as Victor 883's | programmer1 | Programming | 13 | 10-03-2004 21:51 |