How to clean a Victor? - Chief Delphi

It would be a lot easier if students would quit being so magnificent. Really. - JaneYoung [more]

		Chief Delphi > Technical > Electrical
How to clean a Victor?

Thread Tools

Rate Thread

Display Modes

22-08-2008, 02:12

Protronie

Have big wrench...and will use it!

no team

Join Date: Dec 2006

Rookie Year: 2006

Location: North Carolina

Posts: 617

Re: How to clean a Victor?

Yeah man, stay away from the compressed air... not only are you driving stuff deeper. If your using a standard shop air compressor set up, your tossing oil & water all over everything.

Shop vac the better way to go, I always use a small soft paint brush to help loosen anything chips that might be bothersome about being sucked up.

Don't forget your PPE's when doing it and be sure the robot is powered down.

-p

__________________
Protronie rule 5 - When the big wrench starts swinging, get out of the way!

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Clean Field!	Joe Matt	Extra Discussion	6	19-03-2006 00:00
Victor 884's not behaving the same as Victor 883's	programmer1	Programming	13	10-03-2004 21:51

All times are GMT -5. The time now is 15:08.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.