|
|
|
 Competitions are won or lost far away from witnesses, ... In those long hours, is where we find inspiration in ourselves. For what inspires is not another's feats, but realize we have the power in ourselves to achieve that feat. - Mark Sheridan [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
Re: Flanged Roller Bearings
Just some clarification in that you will need to design in a method of adjustment for the tapered roller bearing, and be able to maintain this adjustment. A castle nut/cotter pin configuration such as found on older vehicle front wheel bearings are a common design solution. The race portion of the bearing is usually press fit into a bore with a shoulder to set the race spacing.
 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Roller Prototype | sdexp | Robot Showcase | 0 | 04-02-2006 22:41 |
| Looking for 1/2" id flanged bearing .25" thick or less (with flange) | Travis Covington | Technical Discussion | 17 | 12-12-2004 21:26 |
| Uneven Thrust Loads on Needle Roller Bearings | Madison | Technical Discussion | 7 | 07-02-2004 01:00 |
| Where to get 1/2" Flanged bearings? | sanddrag | Technical Discussion | 13 | 15-01-2004 22:04 |
| Cheapest place to get 3/8 inch ID double sealed flanged precision bearings? | Travis Covington | Technical Discussion | 5 | 24-02-2003 22:39 |
Why is there never enough time to do it right, but always enough time to do it again!
Hybrid Mode
