|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||
|
|||
|
Re: Goal Construction
Posted by Rob Gordon at 1/12/2001 1:07 PM EST
Engineer on team #69, H.Y.P.E.R., from Quincy Public Schools and The Gillette Co.. In Reply to: Goal Construction Posted by Gary Bonner on 1/12/2001 11:55 AM EST: It looks like the 12.5" radius is to the center of the flanges. But it isn't 100% clear. The quickest source for the Al pipe is McMaster-Carr. They take credit card orders, and you will have it in one day (most of the time). They are not cheap though. Their web site is http://www.mcmaster.com/ Good luck, Rob : The plans indicate a radius of 12.5 inches for the flange bases on the goal. Is that to the center or edge of the flange? : What’s a good source for the schedule 40 Al pipe? : Thanks |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FIRST and Success: A Question of Definition | Madison | General Forum | 70 | 27-11-2002 08:42 |
| Small balls in 2001 competition | archiver | 2001 | 10 | 24-06-2002 03:59 |
| Curie Division Robots information... (not complete) | archiver | 2001 | 3 | 24-06-2002 03:13 |
| Just curious, how many robots could shoot or toss balls into the goal? | Alan Ing | General Forum | 7 | 13-05-2002 19:09 |
| How hard is it to pull a goal? | Ken Leung | General Forum | 19 | 17-01-2002 20:09 |