|
Can we really get 225 in-lbs from the drills?
Posted by Jason Rukes at 1/12/2001 1:53 PM EST
Engineer on team #109, Arial Systems & Libertyville HS, from Libertyville High School and Arial Systems Corp & SEC Design.
One of Woody's slides during the Kick-Off showed that a current-limited motor will have the same max speed, but less torque than a "current-unlimited" motor. That got me thinking about the drill motors and the effect of the 30A circuit breaker.
The datasheet states the drill motor will stall at 225 in-lbs(low speed). The torque constant is 5.836mN-m/Amp which means the motor can only generate 62in-lbs of torque at 30 amps before tripping the breaker.
Does this sound correct?
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
They may call us geeks and nerds, but deep down under that prejudice they know they want to be the hard-core, sleep-deprived, hand drill-toting, robot builders we know we are! - vijay24 [more] 
Similar Threads
Threaded Mode