Servo 'smoothing' - Chief Delphi

Same as regrets in life: Learn from them. This is called "growth". - DonRotolo [more]

		Chief Delphi > Technical > Programming
Servo 'smoothing'

Thread Tools

Rate Thread

Display Modes

10-09-2008, 21:56

dgitz

Registered User

FRC #2219

Join Date: Apr 2008

Location: Carbondale, IL

Posts: 9

dgitz is an unknown quantity at this point

Re: Servo 'smoothing'

Put your signal line on an o-scope and you can look at the jitter there. I would try then putting a low-pass filter on it to reduce some of the noise. my 2 cents.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Data Smoothing	Lafleur	Programming	3	14-01-2008 22:06
Servo behavior question / advanced servo/PIC programming question	DanL	Electrical	12	18-10-2005 18:33
Servo Values	DanDon	Motors	8	14-02-2005 15:49
Buying Servo	Gamer930	Motors	4	13-02-2005 20:44
Servo	MASherry	General Forum	6	04-10-2004 22:46

All times are GMT -5. The time now is 19:21.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.