Goal Building - Chief Delphi

"Is it possible to cut enough holes in the robot to weight reduce 8 lbs?" - ScoutingNerd175 [more]

		Chief Delphi > Old Forum Archives > 2001
Goal Building

Thread Tools

Rate Thread

Display Modes

23-06-2002, 22:51

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Goal Building

Posted by Charlie at 1/13/2001 11:15 AM EST

Student on team #222, Tigertrons, from Tunkhannock Area High School and P&G - Ronco Machine - NEPATPC.

1)What is the length of the bottom horizontial edge of the DP2? 2)When constructing the bridge, what distance does F1(lip on bridge) over lap the R2(plywood)? 3)When cutting the DP2, what are the angle cuts on the ends of each side of the plate?

Thanks,
Charlie

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FIRST and Success: A Question of Definition	Madison	General Forum	70	27-11-2002 08:42
Small balls in 2001 competition	archiver	2001	10	24-06-2002 03:59
Curie Division Robots information... (not complete)	archiver	2001	3	24-06-2002 03:13
Just curious, how many robots could shoot or toss balls into the goal?	Alan Ing	General Forum	7	13-05-2002 19:09
How hard is it to pull a goal?	Ken Leung	General Forum	19	17-01-2002 20:09

All times are GMT -5. The time now is 01:14.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.