|
|
|
 Swerve is hard to get right. - marshall [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Swerve is hard to get right. - marshall [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
19-09-2008, 10:45
|
||||
|
||||
|
Re: [FTC]: Motors
On the subject of motors, does anyone more specs on the motors? Specifically I'm looking for current draw specs -- Stall Current and Free Speed Current. Here's what I have so far:
Stall Torque = 300 oz-in = 2.12 N*m (slightly less than a CIM) Free Speed = 152 RPM This is all gravy for figuring out how fast a drive train goes, but not good enough to figure out if the motors will survive pushing match after pushing match. Then there's the question of how hard you're straining the motors by lifting the robot arm with some weight at the end of it. Anyone? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: First problem with FTC and LabView.....? | PhilBot | FIRST Tech Challenge | 5 | 07-11-2008 10:36 |
| [FTC]: Rookie Team Needs Help With Tetrix FTC Kit! | rjustice4 | FIRST Tech Challenge | 8 | 05-10-2008 09:44 |
| [FTC]: FTC]: FTC Champ Tournament - Ontario (Scoring Breakdown) | Mr. Lim | FIRST Tech Challenge | 2 | 03-03-2008 11:54 |
| [FTC]: [FTC]: Ontario Provincial FTC Start/End Times | cbhl | FIRST Tech Challenge | 8 | 16-12-2007 13:37 |
| [FTC]: Hey FTC teams, Vex and a chance to be on MTV? | Rich Kressly | FIRST Tech Challenge | 1 | 12-09-2007 13:35 |
Threaded Mode