Bar Height - Chief Delphi

I've determined that the only thing rumors are good for is putting your knickers in a twist. - JaneYoung [more]

		Chief Delphi > Old Forum Archives > 2001
Bar Height

Thread Tools

Rate Thread

Display Modes

23-06-2002, 22:54

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Where's the error?

Posted by Rick Gibbs at 1/14/2001 11:34 PM EST

Engineer on team #145, T-Rx, from Norwich High School, Sherburne-Earlville High School and Procter & Gamble Pharmaceuticals.

In Reply to: 14-1/4" for P16 may not be right... check this out.
Posted by Andy Baker on 1/14/2001 11:26 PM EST:

I had noticed that, too. So, I guess the height of the rail is all dependent upon where the error in the print is.

If it's 16" instead of 14-1/4", there's an extra couple inches of breathing room

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Grab bar on bottom of goals	archiver	2001	0	24-06-2002 00:49
how effective do you think robots going under the bar	archiver	2001	4	24-06-2002 00:36
actual O.D. of grab bar of goal?	archiver	2001	1	23-06-2002 23:20
How many robots on the bar in one match?	archiver	2000	14	23-06-2002 22:39
height questions	Team461	Off-Season Events	3	29-10-2001 21:51

All times are GMT -5. The time now is 12:29.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.