|
Holy Cow, I missed that one!
Posted by Andy Baker at 1/14/2001 11:35 PM EST
Engineer on team #45, TechnoKats, from Kokomo High School and Delphi Automotive Systems.
In Reply to: Check Again
Posted by Gary Bonner on 1/14/2001 11:20 PM EST:
: Rule M14 specifically states: You may not use materials from SMALL PARTS INC (tubing, fittings, etc.) for pneumatics.
Oops! I missed that one. I should think twice before saying that I'm sure about something.
Not being able to use Small Parts fittings makes no sense to me. I'll wait until later to rant about this.
Andy B.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|