|
Re: Bevel Gears on Drivetrain
Posted by Rob Gordon at 1/16/2001 12:47 PM EST
Engineer on team #69, H.Y.P.E.R., from Quincy Public Schools and The Gillette Co..
In Reply to: Bevel Gears on Drivetrain
Posted by Michael Quayle on 1/14/2001 10:57 PM EST:
We utilized bevel gears last year, and had a fantastic drive train with very few problems. However, we used fairly large steel gears. We prototyped the year before using the gears from small parts and trashed them in a few minutes. I would keep your design for another year when they allow us to use gears from outside sources.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|