|
|
|
 The question was asked. The GDC gave their ruling. If you don't like it then maybe you can run your own tournament and let people ignore your rulings. - Daniel_LaFleur [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The question was asked. The GDC gave their ruling. If you don't like it then maybe you can run your own tournament and let people ignore your rulings. - Daniel_LaFleur [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
01-10-2008, 13:57
|
|||||
|
|||||
|
Re: Best hand tool to use to cut sheet metal (aluminum diamond plate)?
What would be the best air tool to cut something like this?
I have a compressor setup, & I didn't even think of that before.  This is my first venture into cutting metal. I have more experience with wood, but as my projects get a little more complex, I may need to invest in some more metal cutting & forming tools anyways. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ALuminum jig plate - cheap surplus | Dick Linn | Technical Discussion | 0 | 19-12-2007 12:40 |
| Rules concerning manipulating circular diamond plate on a spider leg for stability | Drew | Rules/Strategy | 3 | 09-01-2007 14:51 |
| How do you tell whether your sensor is detecting a crate or the diamond plate? | Greg Ross | Technical Discussion | 4 | 13-01-2003 19:02 |
| Aluminum Plate | archiver | 2001 | 1 | 24-06-2002 00:03 |
| 1/4" Aluminum Plate | Brian_Lim | Rules/Strategy | 3 | 15-01-2002 18:32 |
Threaded Mode