Hex Shafts and Bearings

#17

03-10-2008, 20:51

Richard Wallace Richard Wallace is offline

I live for the details.

FRC #3620 (Average Joes)

Team Role: Engineer

Join Date: Jan 2003

Rookie Year: 1996

Location: Southwestern Michigan

Posts: 3,689

Richard Wallace has a reputation beyond repute

Re: Hex Shafts and Bearings

Quote:

Originally Posted by Dick Linn

... Stock Drive Products has round sleeves with a hex hole:

www.sdp-si.com/D790/PDF/D790C04023.pdf

Quote:

Originally Posted by sanddrag

Small Parts sells hexagonal sleeves, but they aren't cheap.

The Small Parts item appears to have the same properties as the SDP-SI item that Dick linked just above. The SDP-SI item is priced much lower.

AndyMark sells a very nice hex hub for $15 each.

Now if someone would offer hex shafts that are turned down to 0.4995 inch on one end...

__________________
Richard Wallace

Mentor since 2011 for FRC 3620 Average Joes (St. Joseph, Michigan)
Mentor 2002-10 for FRC 931 Perpetual Chaos (St. Louis, Missouri)

since 2003

I believe in intuition and inspiration. Imagination is more important than knowledge. For knowledge is limited, whereas imagination embraces the entire world, stimulating progress, giving birth to evolution. It is, strictly speaking, a real factor in scientific research.
(Cosmic Religion : With Other Opinions and Aphorisms (1931) by Albert Einstein, p. 97)

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bearings and axel size	Adama	Technical Discussion	10	19-01-2007 14:15
keeping hex-shaped shafts in the couplings	DaveG702	Motors	5	02-02-2003 21:03
shafts, gears and wheels....	archiver	2001	13	24-06-2002 04:09
A little tip about those drill transmissions and bearings	archiver	2001	6	24-06-2002 00:22
Are bolts to hold wheels on, and bearings, considered "fasteners"?	kmcclary	Off-Season Events	3	22-10-2001 23:35

All times are GMT -5. The time now is 04:34.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.