|
|
|
 All the same lessons that can be learned or taught with custom drive trains can also be learned or taught with custom manipulators and scoring mechanisms, and the latter is far more likely to set your team apart in the competition. - Jared Russell [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
09-10-2008, 00:08
|
|||||
|
|||||
|
Re: pic: Direct Digital Manufacturing! (DDM)
Good ONE Wetzel!
 For those of you who don't know .stl(industry standard 3d print file format) do not carry units. For example if I designed a 1 inch cube in solidworks, saved it as .stl, imported it into my software, my software doesn't know if it was drawn in mm or inches. If I selected inches in my software it would be 1 inch, but if I selected mm it would be much much smaller than 1 inch!  BTW the #'s 768 and 1200 in the Dimension 3d printer lineup stand for the build volume it has. 8x8x12 inches = 768 cubic inches 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: NI cRIO-FRC at Manufacturing in Hungary 4 | jhersh | Extra Discussion | 2 | 01-10-2008 04:44 |
| pic: NI cRIO-FRC at Manufacturing in Hungary 2 | jhersh | Extra Discussion | 1 | 30-09-2008 12:18 |
| pic: NI cRIO-FRC at Manufacturing in Hungary 3 | jhersh | Extra Discussion | 10 | 28-09-2008 10:54 |
| pic: Outback Manufacturing Drive train | pakratt1991 | Extra Discussion | 6 | 08-04-2007 03:08 |
| pic: 1097 Direct Drive 01 | Anthony Kesich | Robot Showcase | 16 | 13-09-2005 22:33 |
Threaded Mode