|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools |
Rating:
|
Display Modes |
|
#16
|
||||
|
||||
|
Re: Team 39, 2008 LabVIEW Beta Code
New Revision posted here: http://hhsrobotics.org/forums/viewto...f=4&t=3&p=6#p6
|
|
#17
|
|||
|
|||
|
Re: Team 39, 2008 LabVIEW Beta Code
It looks like you have lots of things hooked up and working. I don't see any timing in your BIG loop with all of your dig I/O stuff. That of course means it runs all out in parallel with everything else. If you can determine a time for it to run based on response, that will likely help with the responsiveness of the other loops.
My guess is that you can put a Wait of 20ms, similar to the camera loop. If that seems too slow, lower the number. Greg McKaskle |
|
#18
|
||||
|
||||
|
Re: Team 39, 2008 LabVIEW Beta Code
Quote:
I was using a Timed loop before that but since that was not provided with the default FRC labview, i switched it to a while loop. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Posting LabView Code Easily? | Greg Marra | NI LabVIEW | 17 | 25-11-2009 16:49 |
| LabView FRC Toolkit code level issue | KHall | National Instruments LabVIEW and Data Acquisition | 2 | 11-06-2008 10:40 |
| [TBA] Match Archives 2008 (beta) | Greg Marra | The Blue Alliance | 16 | 07-10-2007 14:39 |
| Configuring Labview code to easyC | team877 | LabView and Data Acquisition | 6 | 16-01-2007 09:21 |
| LabView Gear Tooth Sensor Code | SkiRacer | LabView and Data Acquisition | 2 | 17-01-2006 03:53 |