|
|
|
 You pick the best person for the job whether they are black, white, asian, hispanic, female, or male; NOT so you 'look good' when they publish your team picture in the school paper, but because they can get the job done right, on time, with a passion. - Pavan Dave [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
10-10-2008, 23:37
|
|||||
|
|||||
|
Re: [FTC]: FTC Labview questions
The HiTech motor controller can get plugged into any of the NXT's INPUT ports (I know... seems BTF, but it's just a data port).
You can plug one controller into a NXT port, and then daisy chain more controllers from this to the next. This gives you a lot of expansion. Whenever the LabVIEW code asks for a "Port" it wants to know which NXT port you plugged into. I'd stick with Port 1 'cos it's the default in most cases. The other thing that it asks is what "controller" it is. Here it wants to know which controller in the daisy chain did you connect the motor to. The one that's plugged directly into the NXT is controller '1' and then then next in the chain (if you have one) is controller '2' etc. In most cases the port and controller will be '1'. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: First problem with FTC and LabView.....? | PhilBot | FIRST Tech Challenge | 5 | 07-11-2008 10:36 |
| [FTC]: Rookie Team Needs Help With Tetrix FTC Kit! | rjustice4 | FIRST Tech Challenge | 8 | 05-10-2008 09:44 |
| [FTC]: FTC]: FTC Champ Tournament - Ontario (Scoring Breakdown) | Mr. Lim | FIRST Tech Challenge | 2 | 03-03-2008 11:54 |
| [FTC]: [FTC]: Ontario Provincial FTC Start/End Times | cbhl | FIRST Tech Challenge | 8 | 16-12-2007 13:37 |
| [FTC]: Hey FTC teams, Vex and a chance to be on MTV? | Rich Kressly | FIRST Tech Challenge | 1 | 12-09-2007 13:35 |
Threaded Mode