|
|
|
 Between Andy B. and Andy G. being Andy A. has some unspoken expectations put on it.
- Andy A. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Between Andy B. and Andy G. being Andy A. has some unspoken expectations put on it.
- Andy A. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
[OCCRA]: A Big Robot Programming Question
As we were getting our control box finalized today, I turned my attention to the programming. After mapping some outputs onto the correct joysticks and buttosn I built and compiled like normal and downloaded it to the microcontroller.
"CODE VIOLATION" the robot blinked. Figuring that I had done something wrong, I reverted to the original code, and downloaded again. "CODE VIOLATION" the robot blinked. After trying to download the original code several more times and getting the same result each time, I dowloaded the Master Code, and then tried again with the Original user code. "CODE VIOLATION" the robot blinked. Does anyone have any idea as to what could be wrong? The codes we tried to download had clean builds every time, and we're using the '04 code - The oldest we have. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OCCRA]: 2008 OCCRA Easy_C Programming Template | marccenter | OCCRA Programming | 2 | 22-11-2008 22:11 |
| [OCCRA]: This OCCRA Programming Forum | Mike Martus | OCCRA Programming | 0 | 04-09-2008 22:12 |
| [OCCRA]: [OCCRA]: Motor Question | JoeFryman | OCCRA Q&A | 1 | 21-09-2005 21:25 |
| [OCCRA]: [OCCRA]: Robot spending limit? | Eric Yahrmatter | OCCRA Q&A | 1 | 13-09-2005 20:31 |
| A Big Question?????? | archiver | 2001 | 7 | 23-06-2002 22:49 |
Threaded Mode