|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
|||||
|
|||||
|
Re: Vibrations during CNC
Clamp that part of the workpiece better.
I think what you are saying is that the waste part of the hole you're making starts jumping around, right? If so, make the cut in more than one pass - almost all the way through to start, then using only a very light cut for the finish. Or exclude the middle of the sides at first, then take them last. Or clamp the middle of the waste rectangle (drill a hole and bolt thru to the work table) And yes, slowing down the cutting speed (not the tool speed!) may help. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intelitek CNC Motion - Virtual CNC Machines | Kingofl337 | Programming | 0 | 19-03-2008 11:29 |
| CNC Machines | DEAL234 | Technical Discussion | 17 | 07-02-2007 16:30 |
| CNC Options? | Andrew Blair | Technical Discussion | 5 | 06-02-2006 18:12 |
| Centroid CNC | team222badbrad | Technical Discussion | 25 | 09-11-2005 20:36 |
| To CNC? Or not to CNC? | phrontist | General Forum | 21 | 26-03-2004 13:45 |