Pneumatics electrical wiring and programming

My hammer is my therapist, my weapon against bent metal, unwilling bolts, and tall nails. - Morgan Gillespie [more]

		Chief Delphi > Old Forum Archives > 2001
Pneumatics electrical wiring and programming

Thread Tools

Rating:

Display Modes

23-06-2002, 23:10

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Pneumatics electrical wiring and programming

Posted by Dan Grostick at 1/18/2001 10:08 AM EST

Engineer on team #267, Demolition Squad, from North Broward Prep / St. Andrews.

I've posted information (in the White Papers section) on the electrical wiring and programming of the pneumatics subsystem. I want to share my experiences programming the pneumatics demo board shown at the First kickoff.

Dan Grostick (267)

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error found in programming for the pump and pressure switch	sjharobotics	Programming	4	06-02-2002 17:46

All times are GMT -5. The time now is 11:30.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.