|
Re: Wiring the actuator
Posted by Dan Grostick at 1/22/2001 9:44 AM EST
Engineer on team #267, Demolition Squad, from North Broward Prep / St. Andrews.
In Reply to: Wiring the actuator
Posted by Patrick Dingle on 1/18/2001 3:42 PM EST:
For prototyping purposes, an inexpensive way is to use a modified integrated circuit socket - just cut off the extra positions. These are available at Radio Shack.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|