|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: pic: The Mammoth3
500 wow thats a lot
what wheels were you planning on using becuase they will need to be strong |
|
#2
|
|||||
|
|||||
|
Re: pic: The Mammoth3
We were thinking about using omni's in the front for turning and putting pneumatic wheels in the back. So a 6wd.
|
|
#3
|
||||
|
||||
|
Re: pic: The Mammoth3
off the AM website
"Maximum workable payload, per wheel: 45 pounds" what size pnuematic wheels ? make sure that you have a low enough COG so that when you mave you dont just fall over! ![]() |
|
#4
|
|||||
|
|||||
|
Re: pic: The Mammoth3
I was looking at that, 45 pounds. So we were going to double them up in the front and drop the center wheels a tad (1/16). So this way the weight is shifted towards the back. Then use 8 inch pneumatic wheels in the back because they are rated for 200 lbs, any suggestions on the wheels.
|
|
#5
|
||||
|
||||
|
Re: pic: The Mammoth3
i couldent say probobly whatever ones you have around
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Team 234 and 1730 in the air after the winning lift from 1555 to capture the Boilermaker Regional | Chris Fultz | Extra Discussion | 2 | 22-03-2007 00:00 |
| pic: The end of nationals...everyone left at the same time | CD47-Bot | Extra Discussion | 15 | 21-11-2004 18:50 |
| pic: My vote for the best design from the team spirit "drawn" in the stands. | CD47-Bot | Extra Discussion | 4 | 07-09-2004 00:19 |
| pic: The Man, The Myth, The Legend, The Symbol | CD47-Bot | Extra Discussion | 6 | 09-04-2003 02:48 |
| pic: 157 and 236 King of the Hill in the finals | CD47-Bot | Extra Discussion | 3 | 16-03-2003 13:03 |