|
Trig
Posted by Nick at 1/19/2001 6:07 AM EST
Student on team #240, Mach V, from Jefferson Monroe High School and Visteon.
For all you Pre Calc and above students-
Is there any way to go from arctangent (X/Y) to Sine and Cosine?
I need to use it in programming and the chip doesn't use arctangent, tangent, arcsine, or arccosine!
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
FIRST robots definitely meet many commonly agreed upon definitions of robots. Some will disagree. Good for them. In my opinion, it's not worth arguing over. - Mikell Taylor [more] 
Similar Threads
Threaded Mode