|
|
|
 Wins = Attention
Attention = Sponsors
Sponsors = Money
Money= being able to do more.
a vicious cycle...but it is what it is - Protronie [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Wins = Attention
Attention = Sponsors
Sponsors = Money
Money= being able to do more.
a vicious cycle...but it is what it is - Protronie [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Distance Between Holes in Blocker?
What is the distance between the centers of the 4 holes in the blocker?
Are all of the holes in the blocker the same diameter (2.25")? Thanks, Jim Meyer 
|
|
#2
08-10-2001, 09:59
|
|||
|
|||
|
Each hole is 2.25 and the distance from the center of each circle is 9.5
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Making a series of spaced holes around a cylinder in inventor | James114 | Inventor | 13 | 21-11-2004 18:44 |
| optimum sensing distance for sensors | DaveG702 | Electrical | 3 | 31-01-2003 22:06 |
| Go Home Device Advice? | Eric Reed | Technical Discussion | 8 | 18-03-2002 08:14 |
| Tapped Drill motor holes: thread anyone? | joe_balint | Motors | 2 | 16-01-2002 08:40 |
| Drill holes | nick reynolds | Rumor Mill | 10 | 12-01-2002 01:39 |
Linear Mode
