|
|
|
 I'm not worried about the amount of Segways at a regoinal, I'd rather see them out in the real world than at a robotics competition. - Joe Matt [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm not worried about the amount of Segways at a regoinal, I'd rather see them out in the real world than at a robotics competition. - Joe Matt [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
[FTC]: parts that should have been made??
I think that the tetrix kit is lacking a few parts that you cant buy and would be beneficial to everyone. I think there should be long axles, 100mm is not long enough. Some kind of linear slide metal pieces and the flat strip of gear like vex had would be good. Also the tetrix angle metal should have the same hole pattern as the channel does. Omni wheels whould be a nice addition too. Anyone else have other parts they wish were made????
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Simple things that have made your life better or easier | KenWittlief | Chit-Chat | 15 | 25-10-2005 06:16 |
| pic: Segways have been around longer that we've thought! | Erin Rapacki | Extra Discussion | 7 | 25-09-2005 21:56 |
| Should all three pneumatics pistons have been received? | Jordan A. | General Forum | 6 | 08-01-2002 13:48 |
| Should the stretcher have been used more? | Tom Fairchild | General Forum | 8 | 26-08-2001 02:40 |
Threaded Mode