|
|
|
 No, I've never done 3D programming before, but I'm young and naive, so I still think I can do it. ;) - Ryan M. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| No, I've never done 3D programming before, but I'm young and naive, so I still think I can do it. ;) - Ryan M. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
09-11-2008, 20:24
|
||||
|
||||
|
Re: pic: 6wd chassis
1/4" thick is always more expensive because it is more material. In the age of bumpers, a properly supported 1/8" plate will more than stand up to the abuses of FIRST. If you want to increase the strength substantially without increasing weight by too much you could bend the plates on the top and bottom to create a flange. This will increase the stiffness of the plate dramatically.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: FRC1293 Prototype 6wd Chassis | Thermal | Extra Discussion | 16 | 06-01-2009 23:12 |
| 6WD Chassis Stiffness vs. Maneuverability | IKE | Technical Discussion | 35 | 07-12-2008 16:04 |
| pic: 6WD Design Iteration | Madison | Extra Discussion | 7 | 01-01-2008 14:00 |
| Need pictures of chassis for 6WD | team2061 | CAD | 6 | 24-12-2007 14:51 |
| pic: 6WD Module | Madison | Technical Discussion | 20 | 12-01-2007 10:09 |
Threaded Mode