|
No Fisher Price Shafts Here
Posted by Michael Ciavaglia at 1/22/2001 7:11 AM EST
Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Interior Systems.
In Reply to: Re: Fisher Price & Shafts...
Posted by Patrick Dingle on 1/21/2001 7:41 PM EST:
Last year we initially used the non-standard shaft that comes with the units. That shaft caused me immense pain and suffering.
My recommendation is to get rid of the odd ball shaft. Use a 1/2" shaft. You will need to bore out the plastice housing so the shaft will fit through. We welded a sproket to a thin plate of aluminum and then screwed this to the removeable black plastic "top hat". If memory serves correct, I think we put a bushing on the back side of the housing to hold it centered to the shaft. We also had a bushing between the sproket/plate and the shaft.
This worked quite well and we were pretty happy and did not have to address issue again.
Just my 2 cents.
Mike C.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
No, I dont mix robots and girls. - Tom Bottiglieri [more] 
23-06-2002, 23:22
Similar Threads
Threaded Mode