pic: re-modified 6wd - Chief Delphi

18-11-2008, 14:21

Andy Baker Andy Baker is offline

President, AndyMark, Inc.

FRC #3940 (CyberTooth)

Team Role: Engineer

Join Date: May 2001

Rookie Year: 1998

Location: Kokomo, Indiana

Posts: 3,416

Andy Baker has a reputation beyond repute

Re: pic: re-modified 6wd

Neat design

Since we are discussing the bottom plate and electronics mount... why not combine the two? You could make your plate bigger, and get rid of the polycarbonate sheet at the same time. If you make that bottom plate out of 3/32 - 1/8" thick perforated aluminum, then you have a rigid bottom plate that doubles as an electronics mount panel.

Andy

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Modified Andy Mark 2 speed gearbox	sam shawe	Extra Discussion	3	29-04-2011 00:22
pic: 6wd chassis	spc295	Extra Discussion	21	10-11-2008 09:00
pic: Team 587 2008 modified joystick	lukevanoort	Control System	9	03-02-2008 22:04
pic: 6WD Module	Madison	Technical Discussion	20	12-01-2007 10:09
pic: A nikko RC car, modified	Andy A.	Extra Discussion	11	20-03-2005 11:59

All times are GMT -5. The time now is 01:43.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.