|
|
|
 Remember, FIRST is a great opportunity that will get you ahead in the long run but don't forget about the short run either. - ChrisMcK2186 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Remember, FIRST is a great opportunity that will get you ahead in the long run but don't forget about the short run either. - ChrisMcK2186 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Need Help on Shaft Mounting...
Posted by Anton Abaya at 1/23/2001 2:08 AM EST
Coach on team #419, Rambots, from UMass Boston / BC High and NONE AT THE MOMENT!  .Assuming we wanted to mount some fixed shafts for wheels to spin on, what have you guys done in the past? Last year we had mounts that were unberaably difficult to disassemble when it was needed and so it brought more problems than expected. Say we wanted to mount the shaft on both sides (it's supported by two mounts), what would you guys recommend for easy disassembly and easy installation? The less machining the better. -anton |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can you stop a pneumatic pump at half shaft | mjt902 | Pneumatics | 16 | 06-02-2003 11:58 |
| Wheel mounting | Moshingkow | Technical Discussion | 15 | 09-10-2002 19:25 |
| Motor coupling | archiver | 2001 | 19 | 23-06-2002 23:35 |
| shaft drive | Joseph F | Technical Discussion | 5 | 03-02-2002 17:51 |
| Connecting new gear to shaft? | mnkysp6353 | Technical Discussion | 10 | 29-01-2002 05:12 |
Threaded Mode