HELP!!! VEX malfunction!!!

[ManicMechanic]

Originally Posted by GaryVoshol

I seem to recall a thread from about a year ago on this subject. If the robot stalls out under some condition, when it restarts it goes into auto mode. Check for posts from last December or maybe January or February this year.

Is this the thread you're thinking of?
http://www.chiefdelphi.com/forums/sh...ight=batteries

[Anna B.]

We've figured out what was going on. Instead of using Rx 0 in the code, I used Rx 1. It's all better now. And, as usual, it was the programmers fault.
-Anna

[Andrew Bates]

I'm surprised that using Rx 1 caused problems. Although I have no basis for this from my experience when you Rx0 and you have two controllers set up the one that turns on last will have control. However when you use Rx1 control will always be given to the controller plugged into Rx1 on the MC.

[Jessica Boucher]

Using RX 0 will search for the live port and assign everything to it; so when youre using two controllers, you definitely want to stick to defining RX1 and 2.

Good to hear you're up and running again!

[EricH]

reported

[Led235]

just reprogram it.

[Joe Ross]

post 20 reported again