[FTC]: 35's Drive problem

Monty Python · #1 30-11-2008, 12:55

Make sure you've updated labview. They said there was an error with the move motors vi that would cause the lag.

KayyPii · #2 30-11-2008, 13:03

I have all the updates but I'm still experiencing lag.

wilsonmw04 · #3 30-11-2008, 13:34

Quote:

Originally Posted by Monty Python

Make sure you've updated labview. They said there was an error with the move motors vi that would cause the lag.

We installed both updates from NI site. I double checked the installation process and everything was done correctly. Are there any other updates that I'm not aware of?

ttldomination · #4 30-11-2008, 14:53

Your best chance now would be to try and hook with someone at NI to get some help and try and figure it out.

wilsonmw04 · #5 30-11-2008, 15:28

Quote:

Originally Posted by ttldomination

Your best chance now would be to try and hook with someone at NI to get some help and try and figure it out.

posted:
http://decibel.ni.com/content/thread/1772?tstart=0

let's see what happens.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[FTC]: Problem with two controller setup in Labview	wilsonmw04	FIRST Tech Challenge	2	11-11-2008 19:58
[FTC]: First problem with FTC and LabView.....?	PhilBot	FIRST Tech Challenge	5	07-11-2008 10:36
[FTC]: Team 35's Servo Test	wilsonmw04	FIRST Tech Challenge	11	03-11-2008 21:47
[FTC]: FTC Servo-Motor Problem with Labview	dnhansen	FIRST Tech Challenge	1	26-10-2008 00:43
pic: FTC 35's prototype for 2007	wilsonmw04	Extra Discussion	2	08-11-2007 18:38