|
|
|
![]() |
|
|||||||
|
||||||||
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Help! Tap and drill...
Posted by Ken Leung at 1/24/2001 4:42 PM EST
Student on team #192, Gunn Robotics Team, from Henry M. Gunn Senior High School. My team are trying to obtain a tap and drill that can fit a 3/8"-20 size... It doesn't seems like a standard size as we cannot find such size at Sears, OSH, Ace Hardware... Do anyone know any place in the Bay Area, California or even online where we can obtain such tap and drill set? |
|
#2
|
|||
|
|||
|
3/8 - 20 Tap
Posted by Joe Johnson at 1/24/2001 5:29 PM EST
Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems. In Reply to: Help! Tap and drill... Posted by Ken Leung on 1/24/2001 4:42 PM EST: McMaster.com sells them page 2149 of the new catalog Part number 2595A817 cost $16.42 Joe J. |
|
#3
|
|||
|
|||
|
Re: 3/8 - 20 Tap
Posted by Samuel Lindhorst at 1/25/2001 1:00 AM EST
Engineer on team #240, Mach Vee, from Jefferson High School and Visteon. In Reply to: 3/8 - 20 Tap Posted by Joe Johnson on 1/24/2001 5:29 PM EST: : McMaster.com sells them page 2149 of the new catalog Part number 2595A817 cost $16.42 : Joe J. J & L Industrial they have an office in San Jose, but weborder the thing and get it tomorrow 800 521-9520 P/N TSP-14324K for a plug tap P/N TSB-34327E for a bottoming tap $10.40 either one |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| White Paper Discuss: 2 speed, Shift-on-the-fly TechnoKat Gearbox | CD47-Bot | Extra Discussion | 35 | 23-01-2004 20:16 |
| Drill Mount Suggestions? | Ryan Curry | Motors | 14 | 30-01-2003 00:01 |
| Dear Dr. Joe, Can we have a little drill help please? | archiver | 2000 | 1 | 23-06-2002 22:56 |
| using set screw or dowel pin/pin to hold on drill motor coupler thinggy | Travis Covington | Motors | 1 | 04-02-2002 03:02 |
| Drill Motor Clutches | kacz100 | Motors | 9 | 01-02-2002 01:01 |