|
|
|
 Re: New to programming, any tips?
Join the mechanical team :) - IndySam [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Re: New to programming, any tips?
Join the mechanical team :) - IndySam [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Tricks getting the CRIO to talk to laptop
Hello,
Are there any tricks to get the cRIO to talk to the laptop for re-imaging? I have set the IP address/subnet on the laptop as 10.0.0.6/255.0.0.0 with a crossover cable to cRIO's port 1. The FRC cRIO Imaging Tool will not recognize the cRIO. The Imaging Tool saw the device once but disconnected before our students could finish settingss the options. Any help would be much appericated. We are going to try again tomorrow night. Thank you, Matt 2108 - Mentor 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 24v Power Conector to from the PDB to the cRIO | mcf747 | Electrical | 14 | 01-12-2008 19:19 |
| Students build SEGWAY in 3 months using Labview and the cRIO | neutrino15 | Programming | 31 | 27-04-2008 22:08 |
| Getting two Vex controllers to "talk" to each other | thefro526 | Programming | 1 | 28-05-2007 11:59 |
| Let's talk about traveling to the Championship. | Madison | Championship Event | 11 | 04-01-2004 12:20 |
| Talk about the 'hacking' here. | Brandon Martus | Chit-Chat | 12 | 08-07-2003 15:53 |
Threaded Mode