|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
|||
|
|||
|
Re: Searching for sensors
I should have been more clear, I dont like them for sensing position of a system that has slip. My issue with them was that our drive system had this knack for accelerating quickly and the wheels slipped occasionally. This meant that our robot thought it was further than it was.That being said, I would use these if I needed to know how fast a gear was spinning due to them being a no contact sensor. Mounting an encoder would mean that the encoder shaft would be spinning at High RPM which causes wear and the potential to have them wear out. In short, it depends on your use.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Searching for ... | TLonghorns0593 | Career | 1 | 19-10-2005 22:08 |
| Searching for a Laptop | s0lidMetal | Programming | 12 | 30-03-2005 17:36 |
| Female Roomate Searching for 2005 @ Purdue | Elyse Holguin | Chit-Chat | 1 | 12-02-2005 10:24 |
| searching for sponsors | n0cturnalxb | General Forum | 17 | 21-09-2004 06:14 |
| [FVG]: Searching for 2D Leader | Mike Ciance | FIRST-related Organizations | 9 | 20-07-2004 00:49 |