|
|
|
 Nats allows an exchange of a vast multitude of ideas from everywhere. Not only in robot design, but accents, tool storage, pit design, team spirt, clothing, many things.
- Wetzel [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Invetner 08 - Gears
I've been working with Inventor 08 for a couple of months and I've found on the Design Accelerator that whenever I try to make a gear it comes out with a gear a completely different size than I thought was going to come out. Is there any way to fix that? If not is there anywhere I can download pre-made gears to use of various sizes?
|
|
#2
05-12-2008, 16:33
|
|||||
|
|||||
|
Re: Invetner 08 - Gears
SDP-SI and Firstcadlibrary are both places I go to for gears often.
SDP-SI sometimes only has a few teeth modeled, but usually some cuts and rotates will get you a complete gear.
|
|
#3
05-12-2008, 16:38
|
||||
|
||||
|
Re: Invetner 08 - Gears
IGear from firstcadlibrary. You can edit some details to make it the gear you want. Here is a link: http://www.firstcadlibrary.com/drawi...r(English).zip
thanks, Vivek
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gears | Jack | 3D Animation and Competition | 7 | 08-07-2003 21:39 |
| Gears | Thunder360 | Technical Discussion | 10 | 23-03-2003 11:33 |
| Gears | Thunder360 | Motors | 2 | 17-03-2003 21:58 |
| gears....? | archiver | 2000 | 16 | 23-06-2002 22:58 |
Linear Mode
