|
|
|
 I'm sure there aren't a bunch of rule makers sitting in a board room discussing "What rule can we change now to mess with the teams' heads?" Lets all just sit back and enjoy the regionals! - Rick [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
06-12-2008, 20:49
|
||||
|
||||
|
Re: Programing a Digital Input on the DS in Labview
Quote:
I don't see how i missed that... Although I can't seem to figure out how to set what digital input I am looking at? I see the pin where is says "Driver Station Digital Input (1-8)" but what goes there? a constant? or do i need to wire that to a different block? Thanks! 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4V - 5V signal on Digital Input | tdlrali | Programming | 5 | 06-03-2008 19:06 |
| digital input question... | Kevin Karan | Programming | 9 | 12-04-2004 07:34 |
| counting digital input | CharlieWilken | Programming | 9 | 22-03-2004 19:56 |
| How do u hook up the digital input to the sensor's wires | Fares | Technical Discussion | 2 | 14-02-2003 16:41 |
| Robot Digital Input | Mike Norton | Technical Discussion | 5 | 16-01-2003 14:31 |
Threaded Mode