|
|
|
 I urge them to build the kitbot and repeateadly smash it into a concrete wall in order to sate their anger. It will soon wane when they manage to do more damage to the wall than to the kitbot. That is honestly the reason that we ended up using the kitframe this year. - Andrew Blair [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#23
07-12-2008, 00:40
|
|||
|
|||
|
Re: Need for Aluminum Gears and Sprockets?
I don't honestly see the wieght savings(I know how light it is, I'm just not sure the cost of them justifies the savings). Also, will these be annodized? Or will they be left raw? I know the 7075 is a heck of a lot stronger(automag bodies) than 6061, but is apparently much harder to annodize. This could icrease your cost some.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gears or chain and sprockets? | fredliu168 | FIRST Tech Challenge | 8 | 25-12-2006 01:15 |
| Fabricating Aluminum Sprockets | Madison | Technical Discussion | 20 | 20-09-2006 12:35 |
| Who needs large Aluminum Sprockets? | Joe Johnson | Kit & Additional Hardware | 3 | 30-01-2004 12:11 |
| Gears and Sprockets | Pat Roche | Inventor | 3 | 13-12-2003 18:38 |
| Attaching the Gears and sprockets to the shaft | archiver | 2001 | 2 | 23-06-2002 23:18 |
Threaded Mode