|
|
|
 I can't think of anything [I]better[/I] to do. - Mr. Van [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I can't think of anything [I]better[/I] to do. - Mr. Van [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
07-12-2008, 14:50
|
||||
|
||||
|
Re: All dressed up and nothing to mount...yet.
If you're looking to do a little more you can,
Download the newest versions of the paperwork Read though the data sheets Plug in some PWM cables. Strip the ends of those power leads going into the Victors Remove the Victors (the new benchtop test uses the Jags) Put a couple of pieces of tape on the output shafts (so you can see direction of rotation) tap fingers on the table a few more times. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dressed up and ready to go (pict) | Sunshine | Robot Showcase | 3 | 16-02-2008 23:18 |
| [OCCRA]: Motor mount samples and instructions | Mike Martus | OCCRA Q&A | 0 | 13-09-2004 21:39 |
| Party/Social/Nothing at all | Dima | Regional Competitions | 23 | 21-02-2003 12:57 |
| And yet, ANOTHER questions | cammie825 | Programming | 8 | 13-02-2003 14:48 |
| Calling all Tigerbolt Chatters - And All Newcomers! | Lora Knepper | Chit-Chat | 9 | 11-07-2001 18:09 |
Threaded Mode