|
|
|
 Yes, I have already determined that the device is capable of launching 2,160 Krispy Kreme donuts into the back seat of my Mustang with a vertical displacement of 65 feet, without cracking the sugary glaze on a single donut. - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#18
12-09-2008, 12:27 AM
|
|||
|
|||
|
Re: pic: Cheap 6WD
It would be very easy to put a 1/16" wall aluminum tube in the bearing holes, which would eliminate the risk of the framerail cracking/widening around the bearing.
I think the transmission would like it much better if there are bearings supporting the output shaft in the frame. Tom, the current thought is that the frame members would be oak, and the sheets would be thin plywood. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: re-modified 6wd | spc295 | Extra Discussion | 15 | 11-19-2008 03:14 PM |
| pic: 6wd chassis | spc295 | Extra Discussion | 21 | 11-10-2008 09:00 AM |
| pic: 6WD Module | Madison | Technical Discussion | 20 | 01-12-2007 10:09 AM |
Threaded Mode