Pipe Diameter - Chief Delphi

Thanks, that clears things up a lot, and should probably have been obvious. - Branden Ghena [more]

		Chief Delphi > Old Forum Archives > 2001
Pipe Diameter

Thread Tools

Rate Thread

Display Modes

23-06-2002, 23:45

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Pipe Diameter

Posted by CArobot at 1/27/2001 8:19 PM EST

Other on team #619, CArobot, from Charlottesville Albemarle.

Does any one know if they are refering to 1/2" - 1 1/2" inside diameter or outside diameter for the schedule 40 PVC pipe mentioned on update #2? All of the dimensions given for the playing field were inside but we don't want to assume.

Thanks
CA Robot

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Machining/Engineering Question re: Pitch Diameter	157#1Driver	Technical Discussion	4	08-01-2003 10:57
How can i mount a pneumatic piston to a pvc pipe!?!?!	archiver	2001	4	24-06-2002 01:11
the size of the pipe on the goals	archiver	2001	2	24-06-2002 00:07
Goal pipe spacing too narrow to push balls through???	archiver	2001	6	23-06-2002 22:53
Units for Pipe Measurements	l1jmx	Rules/Strategy	4	10-01-2002 20:33

All times are GMT -5. The time now is 01:24.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.