|
|
|
 of course, like anything, there is big difference between "can" and "should" - ratdude747 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| of course, like anything, there is big difference between "can" and "should" - ratdude747 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Help to Deploy a Program in Labview.
My laptop can find the cRIO controller through the imaging tool, yet if I try to deploy or run any program, it tries to establish a connection, and then quits out. My IP address is the correct one for our team (Team 3006: 10.30.06.6). I have also tried deploying sample code and this does not work either, I am running on Labview. Does anyone have any idea how to solve this?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tip if you ever want to program network applications in LabVIEW | Michael Hill | National Instruments LabVIEW and Data Acquisition | 1 | 24-10-2008 20:31 |
| 97's Ramp Deploy | ZZII 527 | Robot Showcase | 5 | 28-02-2007 15:18 |
| Team 1345's ramp deploy and robot on top. | Arefin Bari | Robot Showcase | 7 | 07-02-2007 17:17 |
| NI LabVIEW and Data Acquisition Pilot Program 2006 Application Ready! | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 2 | 18-10-2006 15:55 |
| help: cannot get the picture in the labVIEW program .. (was: need help!! quickly!) | liad | LabView and Data Acquisition | 8 | 18-01-2006 12:20 |
Threaded Mode