Difference in aluminum

[archiver]

Posted by Sharif Mukhashen at 1/29/2001 7:24 PM EST


Student on team #3010, P.R.O.B.O.T.S, from Dearborn High School and Ford.



IN Appendix C of the hardware list it states we can use angle aluminum and extruded aluminum. What is the difference? Can we use the aluminum angle up to 2x2 and extruded aluminum angle up to 2x3?

[archiver]

Posted by Ken Wilson at 1/30/2001 2:51 AM EST


Engineer on team #248, FEMEX, from Philadelphia Girls High and PECO Energy Company.


In Reply to: Difference in aluminum
Posted by Sharif Mukhashen on 1/29/2001 7:24 PM EST:



: IN Appendix C of the hardware list it states we can use angle aluminum and extruded aluminum. What is the difference? Can we use the aluminum angle up to 2x2 and extruded aluminum angle up to 2x3?

Some aluminum shapes are extruded (remember the Playdoh Factory?) like architectural angle/channel/tube or the Small Parts Bosch extrusions. Some are roll-formed, like structural angle, which the add'l hrdwre list refers to. Metal, like wood has a grain, and rolling a shape orients this grain axially for sectional strength. Hence, the "structural" label.

Yes and yes to the second question's cross-sections.