|
|
|
 remember FIRST is just an extracuricular activity in which most of the work is technichan's work...what gets you into college are good grades and a good course load...as my mom always said, "getting good grades gives you the freedom to chose to be whatever you want and go wherever you want" - abeD [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
12-12-2008, 00:03
|
|||
|
|||
|
Re: Sliding axle tension system
It would be good to increase the screw size, but it's not necessary. Keep in mind, this is only my opinion. If you're tightening the chain enough to bend a screw, your chain is probably too tight. I'd suggest using a #10 screw, then you should be fine. Nice design.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sub-team tension??? | Darkswordsmith | General Forum | 18 | 10-02-2006 21:35 |
| Buying spare Sliding Door Motors | cab2137 | Motors | 10 | 16-02-2005 11:54 |
| Sliding door motor shaft support | Max Lobovsky | Motors | 3 | 14-01-2005 18:39 |
| Globe motor, Sliding Door | Coachmac | Motors | 3 | 12-01-2005 14:11 |
| sliding boxes | Jeff Rodriguez | General Forum | 11 | 11-03-2003 00:24 |
Threaded Mode