|
|
|
 You pick the best person for the job whether they are black, white, asian, hispanic, female, or male; NOT so you 'look good' when they publish your team picture in the school paper, but because they can get the job done right, on time, with a passion. - Pavan Dave [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
12-12-2008, 15:18
|
|||||
|
|||||
|
Re: No connection through Ethernet jacks on DS
That's not good.
The Jaguars are the least of it. Just work at getting the "No Comms" message off the DS. You should be able to at least ping the DS while connected to the ETH2 port. I assume your PC is set to 10.0.56.6 PC mask set to 255.0.0.0 Disable any firewall you may have running for testing. You should have your cRIO IP address set to 10.0.56.2 and your DS set to 10.0.56.5 at this point in the testing. DS ETH1 port connected to the cRIO port 1 P.S. When you updated the cRIO with the FRC cRIO Imaging Tool the settings you were supposed to use would not have resulted in an IP address of 10.0.0.2 Under "Format Controller" Select Image = FRC_2009_v2.zip Device name = FRC-cRIO-56 Team ID = 56 Last edited by Mark McLeod : 12-12-2008 at 15:30. Reason: ETH2 <-> ETH2 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ethernet camera | kamocat | Programming | 9 | 06-09-2008 08:09 |
| Internet Connection? | synth3tk | Scouting | 15 | 08-03-2008 10:33 |
| Embedded Ethernet? | Andrew Blair | Technical Discussion | 6 | 22-06-2006 21:12 |
| Spike Connection | Gal Longin | Electrical | 4 | 12-01-2005 13:59 |
| Championship Connection | Jordan | Rumor Mill | 3 | 13-11-2002 22:41 |
Threaded Mode