Go to Post I hope that all of our new members are as helpful as the one above. We will be in for an amazing season if that is the case. - Greg Needel [more]
Home
Go Back   Chief Delphi > Old Forum Archives > 2001
CD-Media   CD-Spy  
portal register members calendar search Today's Posts Mark Forums Read FAQ rules

 
 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
  #12   Spotlight this post!  
Unread 23-06-2002, 23:53
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
 
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: how much is too much on the DRILL MOTORS?

Posted by Matt Leese at 1/31/2001 6:46 PM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Rochester Institute of Technology.


In Reply to: how much is too much on the DRILL MOTORS?
Posted by Anton Abaya on 1/30/2001 11:16 PM EST:



Along with everything said below, you'll also want to check to make sure that everything in the drive train is aligned correctly (this assumes you're using sprockets and chain). You'd also want to make sure that the chain is tensioned enough but not too much (there should be some play in the chain). Also, just the run the drive train under load. Put some weights on it and just run it. See what happens. If something breaks, it's going to need to be fixed. Let your drivers get some training on it.

Matt who wonders how he's remotely qualified to give advice......


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Complete Drill, Seat, and Window motors for trade archiver 2000 0 23-06-2002 22:16
Complete Drill, Seat, and Window motors for trade archiver 2000 0 23-06-2002 22:16
Blowing drill motors archiver 2000 6 23-06-2002 21:58
"Motors and Drive train edition" of Fresh From the Forum Ken Leung CD Forum Support 6 29-01-2002 12:32
what about the drill motors? Ken Leung Motors 2 26-06-2001 02:11


All times are GMT -5. The time now is 01:13.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi