|
|
|
 IF teams did NOT READ THE FIRST MANUAL AND Q&A SITE, it is not FIRST's fault, it is the TEAM'S fault - sburro [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| IF teams did NOT READ THE FIRST MANUAL AND Q&A SITE, it is not FIRST's fault, it is the TEAM'S fault - sburro [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
15-12-2008, 18:13
|
|||
|
|||
|
Re: Cheap encoders
These are not mechanical encoders. They are optical encoders. The specs, look at this link.
http://docs.bgmicro.com/pdf/oak-grigsby%20encoders.pdf It's hard to tell from the doc if they have sleeve or ball bearings. Any way they should work for attaching to the output of a trans. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Encoders..... | manderson5192 | Programming | 4 | 07-02-2008 10:10 |
| encoders | benjamin1748 | Programming | 6 | 07-02-2007 22:37 |
Threaded Mode