|
|
|
 "The devil" isn't in the details... The devil is having a loud house party with lots of other devils and demons in the details. And laughing, and laughing... - pfreivald [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
18-12-2008, 13:27
|
|||||
|
|||||
|
Re: Default code doesn't seem to match documentation
For Basic Framework - in the Block Diagram for "Basic Robot Main.vi" on the top left you'll see them. (I'd recommend not using the Basic template for now- it has a bug that I'm sure a later patch will fix.)
For Advanced Framework - in the Block Diagram for Begin.vi towards the bottom in the center "column" you'll see them. Documentation always lags production sw... When you created your project did you see the choice for Basic vs Advanced framework shown the the right photo below? If not then you haven't installed the LabVIEW FRC update. Last edited by Mark McLeod : 18-12-2008 at 13:49. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Code for sensor still doesn't work | Ianuser | Programming | 3 | 14-02-2007 10:17 |
| Problems integrating CMUCAM code and IFI Default Code | Windward | Programming | 2 | 06-02-2007 16:48 |
| even simple autonomous code doesn't work?? | colman77 | Programming | 4 | 17-02-2006 23:58 |
| problems using gyro/adc code with camera default code | tanstaafl | Programming | 7 | 22-01-2006 23:09 |
| Inserting Naviagation code into Default code? | actorindp | Programming | 3 | 28-01-2004 18:12 |
Threaded Mode