Drill motor true speed?

254 bends CIM shafts every now and then in the drivetrain. I didn't believe it was possible until I saw it myself. - AustinSchuh [more]

		Chief Delphi > Old Forum Archives > 2001
Drill motor true speed?

View First Unread

Thread Tools

Rate Thread

Display Modes

23-06-2002, 23:58

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Drill motor true speed?

Posted by Raul at 2/1/2001 8:10 AM EST

Engineer on team #111, Wildstang, from Rolling Meadows & Wheeling HS and Motorola.

STill looking for an answer:
The spec in the official document says the top speed of the drill system is 400 RPM in low gear. Various sources say it is between 300 and 400 RPM. Does anyone know the true no-load RPM?

Raul

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
"Automatic Transmission"	Madison	Technical Discussion	70	24-11-2003 09:03
Portable cordless drill press	Gui Cavalcanti	Technical Discussion	25	03-08-2003 22:21
Speed Reduction for Drill Motors	Ian W.	Programming	5	18-01-2003 23:57
Difference in forward/reverse drill motor speed	archiver	2001	25	24-06-2002 00:21
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32

All times are GMT -5. The time now is 16:36.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.