|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
|
|||
|
|||
|
Re: Help!!..wheels?
An alternative to omni wheels on one end and high traction wheels on the other end is to use the relatively hard black plastic wheels typical of caster wheels on one end and high traction wheels at the other end. We have found it to be a very good mix of providing some resistance to being pushed from the side but still providing a benefit of 4 wheel drive. This setup also allows good turning. The black plastic wheels do wear out and sometimes get chunks broken out of them so they typically last 1 - 2 regionals but are relatively cheap and depending on the drive train setup can be easy to replace.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with mecanum wheels | CyDrive | Programming | 7 | 10-02-2008 16:16 |
| need help about Mecanum Wheels | mahmosh | Technical Discussion | 4 | 18-01-2008 11:50 |
| Help with Omni wheels? | atowle1236 | Technical Discussion | 35 | 15-01-2008 11:07 |
| Help with Omni-wheels | The GarbageMan | Kit & Additional Hardware | 12 | 10-04-2007 12:39 |
| Sensitivity Wheels - help please | naor52 | Programming | 6 | 20-01-2006 09:13 |